Caloric Oven Error Codes

Caloric Oven Error Codes THE FIRST STEP in diagnosing ANY oven error code is to attempt to reset the logic board. Press any “stop,” “reset,” “clear” or “off” button, wait for a few minutes and remove power from the unit, either by unplugging it or turning the breaker off for a few minutes. Remember that self-cleaning oven latches are slow-moving. Remember also that a self-cleaning oven latch will not unlock until the oven is back below some pre-set temperature, usually around 550-650 degrees, so in some cases, if the door lock is involved, you may have to wait for an hour or more for the oven to cool off and reset itself.

Caloric Oven Error Code Solutions

CALORIC Range/Stove/Oven Fault Codes

Failure Code – glass link Electronic Range Control (ERC)ConditionCheck/Repair
Door flashing #0, 1, 2, 3Latch switch brokenReplace switch
“Lock” flashingLatch switch brokenReplace switch
F0Loss of safety signalReplace adapter board
F1Watchdog circuitReplace Electronic Range Control (ERC)
F2Oven too hotCheck oven temperature sensor
F3 F4Open or shorted oven temperature sensorReplace oven temperature sensor
F7Shorted touch panelReplace touch panel
F9Motorized door problemCheck door latch
FFDoor lock errorCheck door switch and latch motor
Electronic Range Control (ERC) III / Relay board with separate board / push buttons
F0Shorted touch padReplace touch pad
F1Failed Electronic Range Control (ERC)Replace ERC
F2Oven too hotCheck oven temperature sensor, replace if necessary
F3 F4Shorted or open oven temperature sensorReplace oven temperature sensor
F5, F6, F8Failed Electronic Range Control (ERC)Replace ERC
F7Shorted or sticking buttonCheck glass touch panel alignment, replace if necessary
F9Door latch failureReplace door latch if necessary

CALORIC RST376 Gas Range Fault Codes

Failure CodeConditionCheck/Repair
F1Clock badReplace clock assembly (also called the ERC)
F2Oven temperature sensor defectiveReplace oven temperature sensor
F3Open oven temperature sensorReplace oven temperature sensor
F4Oven temperature sensor low ratingReplace oven temperature sensor
F5Clock failureReplace clock assembly (also called the ERC)
F6Power surge (clock)Try turning off power to appliance for one minute. If problem persists, replace clock assembly (also called the ERC)
F7Touch panel button stuckReplace touch panel (membrane)
F8Failure of diagnostic read-outReplace clock assembly (also called the ERC)

Leave a Comment