Gorenje İnduction Cooker Error Codes
Gorenje İnduction Cooker Error Codes

Gorenje İnduction Cooker Error Codes

Gorenje İnduction Cooker Error Codes We have collected all the error codes of Gorenje induction cookers with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.

Gorenje İnduction Cooker Error Code Solutions

Gorenje İnduction Cooker Error Codes The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error. Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.

Gorenje induction cookers errors, decoding

Error codeDescriptionCauses and solution
LActive child lock.To disable protection, turn the hob off and on, then hold the sensor for 10 seconds until a beep sounds.
F0Water got on the glass or clamped the sensor for more than 10 seconds.Wipe the hob dry, turn the cooktop off and on. Do not blow dry with a hairdryer or vacuum cleaner – this can cause irreparable problems.
F1The optical sensor does not respond.Disconnect the panel from the power and reconnect, operate normally. If the problem persists, call the repair wizard.
F2The tactile sensor is defective, the measuring circuit does not work.Sensors do not respond to contact in case of burnout of the sensors. the ceramic surface in the key area may also be damaged. We recommend a visual inspection and call the repair service.
F3The heating system does not work.When boards and heating modules burn out, the entire device must be repaired in the service. The wizard will find out the cause of the breakdown and replace the components.
F4There is no communication with the device due to a short circuit, PT1000.Do not turn on the equipment yourself, consult with the service immediately and only then take any actions as directed.
F5Damage to the power microcontroller.Most faults are caused by a network short circuit or improper installation and connection of equipment. Contact service for repair.
F6The relay module is not activated, there is no communication with the power module.You can repair or replace the modules by contacting service.
F7Defective microcircuit.Only employees from the service can solder and change microcircuits. You can disconnect the device from the power supply and call a repair technician.
F8Overheating of the hob.First of all, check the ventilation gaps (at least 1.5 cm wide) and listen for the fan noise. Damage to heating elements can only be fixed at a service center.
F9Water has entered the device.If liquid leaks, immediately disconnect the brewing unit from the power supply. Wipe dry. Let it dry naturally and call the wizard to inspect the panel.
F10The power cable is defective.Need to replace the electric cable due to its mechanical damage, short circuit, wear. Contact the service.
F15The temperature sensor is broken.The sensor may not be connected or an open has occurred. In any case, call the wizard from the service for diagnostics and repair.
F16Relay module does not work, power is not connected.Damage to the modules can only be fixed by the master from the service. You need to disconnect the equipment from the network and call a specialist for repair.
F17The touch module does not work.Perhaps due to oxidation of the contacts, the module failed. Liquid leakage and a dirty ceramic surface are not a rare cause of failure. Contact service for repair.
F18Sensor breakdown.Call the wizard to repair the sensor. Perhaps the hob is too dirty and the sensor does not respond to pressure – rinse the surface of the device.
F85Exceeded temperature in the electronic unit.Most likely, the overheating of the device’s working platform affected. Contact a service center for diagnostics and repair of cooling elements.

Leave a Reply

Your email address will not be published. Required fields are marked *