Nemco Food Warmer Troubleshooting
Nemco Food Warmer Troubleshooting

Nemco Food Warmer Troubleshooting

Nemco Food Warmer Troubleshooting From heat shelves to lamps, Nemco has been manufacturing some of the best warmers for years. Their line of equipment lets restaurants and other commercial kitchens keep food hot and ready to serve at a moment’s notice. If these units are having a rare issue, it can cause heavy downtime. With the Nemco food warmer troubleshooting tips below, you can diagnose the problem quickly.

Nemco Food Warmer Troubleshooting Solutions

This guide is to help users identify a potential issue. If you’re only tasked with operating the equipment, please contact an authorized service technician to resolve any of the following issues or identify additional problems.

6301 Heat Shelves, 6100A Soup Warmers & Cookers, 6055A Warmers

  • Isn’t heating – Make sure the unit is plugged in or that thermostat is at the desired heat setting. Also, see if the right amount of water was placed in the well or pan.
  • Food too cool or not at temperature – The food might have been too cold when placed on the warmer. Make sure the product is hot beforehand or increase the warming shelf’s temperature.
  • Food too hot – If the food is too hot, decrease the temperature on the thermostat.
  • Blown fuse or circuit breaker – Try unplugging the power cord from the outlet and seeing if there are short circuits. If the issue persists, have an authorized technician remedy the issue.

6000A Infra-Red Bulb Warmers

  • Light isn’t on – Check if the warmer is plugged in and that the power switch is “ON.” Also, make sure there is power at the receptacle or if the light bulb needs to be replaced.
  • Sockets are loose – With the power off, see if the sockets are loose or broken. You might need to remove the light bulb and fasten the socket screws.
  • Hoods are loose – With the power off, see if the hoods are loose. You might need to remove the light bulb and fasten the hood screws.
  • Blown fuse or circuit breaker – If the circuit isn’t overloaded, have it checked or replaced by an authorized technician.

Leave a Reply

Your email address will not be published. Required fields are marked *