Siemens Induction Cooker Error Codes
Siemens Induction Cooker Error Codes

Siemens Induction Cooker Error Codes

Siemens Induction Cooker Error Codes We have collected all the error codes of Siemens induction cookers with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.

Siemens Induction Cooker Error Code Solutions

The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error. Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.

Error codeDescriptionCauses and solution
Number 0Auto shutdown protection is enabled.Turn off the hob, remove all third-party objects from the surface, if any. Turn on and re-make the necessary settings.
The letter EAuto shutdown worked.Perhaps there are third-party objects on the panel or spilled water. Wipe the hob. Re-enable.
F0The indicator of the induction cooker Siemens is faulty.The cause of the breakdown could be a circuit. Reboot the device, if the problem persists – contact the after-sales service.
F4Activated and does not turn off the “child protection”.A lock may hang for various reasons. Most likely the sensor closed. Unplug for a few seconds and reconnect the hob.

F1 – The hotplate has been switched off by the hob. Most likely this is due to too much overheating. It is best to let the cooking zone cool off completely before you switch it on again.

F2 – The hotplate has been switched off due to overheating electronics. Turn off the appliance and wait for it to cool down. Touch any symbol to turn it on again and the issue should be resolved.

F4 – The entire unit overheated and switched off all the cooking zones. Wait for the induction hob to cool off before switching it back on.

F5 – The hob has detected hot cookware placed in the control area. Placing hot pots and pans in the control area is not allowed. Remove the cookware immediately. After a few moments, the error code should disappear by itself.

F6 – The same meaning as F1.

F8 – This error message could appear if a hotplate has been on for too long and signals that the plate might be overheating. The automatic safety switch needs to be checked for faults. If necessary, it needs to be deactivated.

Leave a Reply

Your email address will not be published. Required fields are marked *