Smeg Oven Error Codes

Smeg Oven Error Codes Each of the following cases is caused by an abnormal operation of theappliance and should be dealt with by a authorised person, please contact your local dealer or Service Center in case you detect any ofthese malfunctioning.

Smeg Oven Error Code Solutions

Error CodesSolution
Err1Defective sensor detected-open or short
Err2Over temperature error
Err3Incorrect probe position
Err4The door locking device has not properlyattached to the door. This might be because thedoor was accidentally opened during itsactivation. Switch off the oven and switch it onagain waiting a few minutes before selecting anew cleaning cycle.
Err5Fan oven heating element faiulure
Err6Oven fan motor error
Err7Grill heating element failure
Err8Tangential cooling fan error
Smeg Oven Parts

Cleaning and Maintenance

  • Before cleaning, remove any dirt burnt onto the stone with the aid of a metal spatula or a scraper of the kind used for cleaning glass-ceramic hobs.
  • For best results, the stone must still be warm; otherwise, wash it in hot water;
  • Use metal mesh sponges or abrasive scotch-brite pads, dipped in lemon or vinegar.
  • Never use detergents.
  • Never wash in the dishwasher.
  • Never leave the stone to soak.
  • The damp stone must not be used for a least 8 hours after the end of the cleaning procedures.
  • Over time, slight cracks may appear on the surface of the stone. This is due to the normal expansion of the stone’s finishing glazes at high temperatures.
Smeg Oven Symbols Means

Smeg Oven Troubleshooting

Smeg Oven Troubleshooting
TroubleCause
The oven display is completely offCheck the mains power supply. Check whether an omnipolar switch upstream of the oven supply line is in the “ON” position.
The oven does not heat upCheck whether it has been set in “showroom” mode.
The controls do not respondCheck whether it has been set in “child lock” mode.
The cooking times are longer than those indicated in the tableCheck whether it has been set in “PO” mode.
After the automatic “pyrolysis” cleaning cycle (only on some models) it is not possible to select a functionVerify whether the door locking device has switched off. If it has not, the oven has a protection device that does not allow functions to be selected while the door locking device is active. This is because the temperature inside the oven is still too high to permit any type of cooking.
If the door is opened during a fan-assisted function, the fan stopsThis is not a fault. It is a normal operation of the appliance, useful when cooking foods in order to avoid excessive heat escaping. When the door is closed, the oven will return to normal operation.

If the problem has not been resolved or in the case of other types of fault, contact your local technical support centre.

Child lock mode: By activating this mode, after two minutes of operation without any intervention from the user, the controls will automatically be locked, indicated by ‘key’ lighting up. To temporarily release the lock during cooking, hold down the temperature selection knob for 5 seconds. Two minutes after the last setting the lock will become active again.

If the symbols on touch-sensitive zones are pressed, the word “BLOC” will appear for two seconds.

Turn Off Show room mode: Activating this mode disables all the heating elements so that only the control panel works (some models also display ‘S’ ). To use the oven normally, set this mode to OFF.

Low power mode: Activating this mode limits the power used by the appliance. Po: HI; normal power. Po: LO; low power. Activating low power mode means that preheating and cooking times may be extended.

One comment

  1. Ruv

    Thank you for this, it was so helpful! Just one question.How do you fix a Err8?

Leave a Reply

Your email address will not be published. Required fields are marked *