Daewoo Dishwasher Error Codes Here is information that will assist you in identifying what may be making your Daewoo Dishwasher display an error code. Identifying what the error or fault code is, will help you to repair your Dishwasher. The Daewoo generalized error fault codes below are to give you an “idea” as to what part is at fault. These Daewoo error codes may not apply to all Daewoo Dishwasher. You may have to do further troubleshooting to find what may be causing the fault for that specific part. For more assistance finding the exact error on your washing machine, please ask a question below. When some malfunctions happen, the appliance will display error codes to warn you.
Daewoo Dishwasher Error Code Solutions
|Door open. The door is opened when the dishwasher is operating.
|Water inlet. Water inlet malfunction.
|Water drainage. Water drainage malfunction.
|Temperature sensor. Temperature sensor malfunction.
|Overflow/leakage. Overflow occurs/Water leakage occurs.
|Water leakage. Water leakage occurs.
|Heating element. Abnormal heating.
If overflow occurs, turn off the main water supply before calling a service. If there is water in the base pan because of an overfill or small leak, the water should be removed before restarting the dishwasher.
Daewoo Dishwasher Troubleshooting
Reviewing the charts on the following pages may make you be free of calling for service.
|Dishwasher doesn’t run
|Fuse blown, or the circuit breaker acted. Replace fuse or reset circuit breaker. Remove any other appliances sharing the same circuit with the dishwasher.
|Power supply is not turned on. Make sure the dishwasher is turned on and the door is closed securely. Make sure the power cord is properly plugged into the wall socket.
|Water pressure is low. Check that the water supply is connected properly and the water is turned on.
|Drain pump doesn’t stop
|Overflow. The system is designed to detect an overflow. When it does, it shuts off the circulation pump and turns on the drain pump.
|Some audible sounds are normal. Sound from detergent cup opening.
|Utensils are not secure in the baskets or something small has dropped into the basket. To ensure everything is secured in the dishwasher.
|Motor hums. Dishwasher has not been used regularly. If you do not use it often, remember to set it to fill and pump out every week, which will help keep the seal moist.
|Suds in the tub
|Improper detergent. Use only the special dishwasher detergent to avoid suds. If this occurs, open the dishwasher and let suds evaporate. Add 1 gallon of cold water to the tub. Close and latch the dishwasher, then start the “pre-rinse” wash cycle to drain out the water… Repeat if necessary.
|Spilled rinse agent. Always wipe up rinse agent spills immediately.
|Stained tub interior
|Detergent with colorant was used. Make sure that the detergent is the one without colorant.
|Dishes and flatware not clean
|Improper program Improper basket loading. Make sure that the action of the detergent dispenser and spray arms are not blocked by large dishware.
|Cloudiness on glassware
|Combination of soft water and too much detergent. Use less detergent if you have soft water and select a shortest cycle to wash the glassware and to get them clean.
|Yellow or brown film on inside surfaces
|Iron deposits in water can cause an overall film. You have to call a water softener company for a special filter.
|White film on inside surface
|Hard water minerals. To clean the interior, use a damp sponge with dishwasher detergent and wear rubber gloves. Never use any other cleaner than dishwasher detergent for the risk of foaming or suds.
|The Detergent dispenser lid cannot be closed properly.
|Clogged detergent residue is blocking the catch. Clean the detergent from the catch.
|Detergent left in dispenser cups
|Dishes block detergent Cups. Re-loading the dishes properly.
|Normal phenomenon. There is some steam coming through the vent by the door latch during drying and water draining.
|Black or gray marks on dishes
|Aluminum utensils have rubbed against dishes. Use a mild abrasive cleaner to eliminate those marks.
|Water standing on the bottom of the tub
|This is normal. A small amount of clean water around the outlet on the tub bottom keeps the water seal lubricated.