Fisher & Paykel Dryer Error Codes

Fisher & Paykel Dryer Error Codes When a continuous series of beeps is sounded, all the lights turn off on the control panel and a number appears on the display, a fault has occurred. The dryer will automatically enter this mode if a fault occurs. The fault code will be displayed as ‘Err’ or show the word ‘Fault’ followed by a number on the digital display. To stop the beeps, touch any button then perform the following steps:

Fisher & Paykel Dryer Error Code Solutions

CODE: F1
PROBLEM: PCB Assembly Fault
FIX: The module has an internal fault. Replace PCB assembly.

CODE: F5
PROBLEM: Over Temperature
FIX: If the exhaust air temperature is above 90 degrees C a fault is given. The dryer should not reach this temperature in normal operation. Check the lint filter and exhaust duct for any blockage or restriction to the air flow.

CODE: F6
PROBLEM: Faulty Exhaust or Ambient Sensor
FIX: The sensors can either be open or shorted circuit. Unplug the exhaust sensor and check the resistance. Should be 2000 ohms at 20 degrees C. Replace the exhaust sensor if faulty. If the ambient sensor is faulty the electronic module will have to be replaced.

CODE: F9
PROBLEM: Faulty Exhaust Sensor
FIX: Unplug exhaust sensor. Check resistance of sensor. If faulty, replace.

CODE: F10
PROBLEM: Exhaust Sensor Shorted to cabinet
FIX: Unplug Exhaust sensor. Check resistance between sensor wires and cabinet. There should be no continuity between them. If there is a short, inspect the harness to trace the short

CODE: F13
PROBLEM: Over Temperature
FIX: If the exhaust air temperature is above 90 degrees C a fault is given. The dryer should not reach this temperature in normal operation. Check the lint filter and exhaust duct for any blockage or restriction to the air flow.

CODE: F15
PROBLEM: Fault Brown out
FIX: The product has experienced 8 brownouts within 60 seconds and has aborted the cycle and displayed fault. Check the supply voltage. If the supply drops below 180 VAC this fault will occur.

Leave a Reply

Your email address will not be published. Required fields are marked *