Haier Dryer Error Codes In case of an improper operation or trouble with the machine when it operates, the code corresponding to the problem will be displayed on the display screen:
Haier Dryer Error Code Solutions
| Error Codes | Solutions |
|---|---|
| C9 | Short Circuit. The PCBs failed. |
| E4 | Heating Element Problem. The humidity sensor failed. The unit will complete thecurrent operating cycle. The unit can still operate under the Time cycles. |
| E5 | The temperature sensor failed. |
| E1 | The door is notclosed tightly. Shut the door tightly and restartthe machine. |
| E2 | There is no changein the temperatures of the laundry inthe tub. |
| E3 | The laundry is not dried. |
| E5 | The thermal sensoropen-circuited or short circuited. |
| E6 | Drain pump fails. |
| E7 | Under voltage or over voltage fault. Check the voltage of power supply. |
| E8 | Over load warning. Check the voltage of power supply. Reduce the load and restart the programme. |
| F2 | Drain pump error. |
| F4 | 1,Temperature of the laundry in the drum does not change. 2,Refrigerant leaks. |
| F32 | The condenser thermal sensor is open-circuited or short-circuited. |
| F33 | The condenser thermal sensor is open-circuited or short-circuited. |
| F5 | Communication failure between PCB and display. |
| cln LInt | The filters is clogged. Clean both filters. |
| H2O FULL | The water tank is full. Clean the water tank. |
| Lo | Ambient temperature is too low. Only use the dryer at ambient temperatures higher than 5 °C. |
Note: All information except for E1 requires turning off the power and then restarting the machine to cancel the code.
Haier Dryer Troubleshooting
In case of power failure, the current programme is stored only for a short time. Usually, a restart of the program is required.
Fiber abrasion results because of wearing and washing the laundry. These fibers (fluff) will be collected during the drying process in the lint filter. The lint filter in the filling opening must be cleaned after each drying cycle to ensure proper air circulation. The shining LED will remind you.
- Remove the lint filter from the drum (fig.: 37).
- Open the lint filter (fig.: 38 and 39) and remove all lint residuals. By using a damp cloth or moistened hand the fluff will be remove easily Detergent residue may be form coating at the fluff filter. In this case, the filter must be cleaned with warm water and a soft brush.
- Reinstall the cleaned lint filter in the tumble dryer (fig.: 40). The symbol only switches off after the appliance was turned off.
- Occasionally the fluff around the housing of the filter as well as on the seal should be removed (fig.: 41).
Do not operate the dryer without or with damaged lint or condenser filter.