Hotpoint Microwave Error Codes If you’re looking for help fixing your Hotpoint Microwave, look no further! Our comprehensive Hotpoint Microwave error code guide will explain common issues, provide tips, and show you how to read your model’s error codes.
Hotpoint Microwave Error Code Solutions
Hotpoint microwave f3 error
This error code signals a control board issue. It can have serious consequences: a microwave that starts cooking by itself is likely to cause fire. Here are the step, which you should take to solve the problem.
- To remove the top grate, remove the two screws. Open the door and take it off very carefully.
- To remove the control panel, remove the screw holding it and press it upwards at the bottom. It will come off easily.
- Check all control board elements for corrosion: it may make unwanted contacts and short your buttons. Clean all parts, which seem rust or stained.
- Put it back together and plug it in.
Other error codes
Even negligence or forgetfulness can cause a breakdown of the microwave oven. In the table below, see the error codes and the reasons for the failure of the device, tips for troubleshooting.
| CODE | CAUSE |
|---|---|
| F01 | Motor circuit fault |
| F02 | Motor fault – open or short circuit |
| F03 | Front thermostat fault |
| F04 | Rear thermostat fault |
| F08 | Heater – open or closed circuit fault |
| F09 | Controller set-up file error |
| F12 | Control module communication error |
| F13 | Air Duct thermostat overheating |
| F14 | Rear thermostat over heating |