Kenmore Microwave Error Codes

Kenmore Microwave Error Codes Kenmore microwave error code f9 If you see this error code on your microwave’s display, reset it. Unplug it for a couple of minutes and plug it back in. This may work if the error was caused by a glitch or power surge. If not, you will need to check the in verter. To be on the safe side, qualified technician.

Kenmore Microwave Error Code Solutions

Kenmore microwave error code SE

Before calling the service center, look in the table for the error codes for your microwave oven model. If an error message appears on the display, or the device does not work, it does not mean that it is broken.

DISPLAYLIKELY FAILURE CONDITIONTHE TECHNICAL DETAILS
F1Thermistor openNo heat or thermistor sensing error
F2Thermistor short for cookingNo heat in 10 seconds after cooking starts
F3Thermistor short after cookingThermistor temperature does not go down after cooking ends
F4Senior openHumidity sensor sensing error
F5

Damper switch sensing error

Kenmore is the brand name for several types of appliances sold by Sears, including microwave ovens. Sears doesn’t manufacture appliances, but instead contracts with other companies such as build appliances. A Kenmore microwave oven that displays a flashing “F9” error code will not operate until the code is cleared from the display screen, which may require internal repairs. Depending on the company that manufactured your particular Kenmore model, the code may involve a wiring problem or a fault door latch. Troubleshoot the oven before calling for repairs.

  1. Fill a microwave-safe cup with water and place it inside the Kenmore. Microwaves should not be operated while empty.
  2. Press the “Cook” button. Enter “60” and press “Start.” If the oven has a problem, it will shut down after 10 seconds and begin flashing “F9” on the display panel.
  3. Open the door and close firmly, and then press the “Start” button.
  4. Cut off power to the Kenmore at the circuit breaker. Wait one minute, and then restore electricity to the appliance. This resets the unit.
  5. Test the microwave again by starting the appliance for 60 seconds. If it continues to shut off and display the “F9” error message, the problem may be with the inverter wiring harness inside the unit. Professional repairs are necessary.

Leave a Reply

Your email address will not be published. Required fields are marked *