How to Change the Electronic Board of the Tumble Dryer
How to Change the Electronic Board of the Tumble Dryer

How to Change the Electronic Board of the Tumble Dryer ?

How to Change the Electronic Board of the Tumble Dryer ? The control board (otherwise known as “PCB” or “Module”) is the electronic unit that controls the programs in your appliance. If there is a fault with the PCB, there is nothing that can be done except for having it replaced. If your tumble dryer is suffering from a faulty PCB, you will be pleased to know that at least you have landed at the right place to help you out!

Dryer Electronic Board Replacement

Important: Before replacing a part in any electrical appliance, you should make sure that the appliance is unplugged.

  •  Shut off the power

    Unplug the dryer and shut off the gas.

Remove the top panel

How to Change the Electronic Board of the Tumble Dryer ? Slide the dryer away from the wall. On the back of the dryer, locate the two hex-head screws that secure the top panel to the frame. Remove the screws using a 1/4-inch nut driver. Pull the top panel back slightly to release the tabs behind the console. Pull the top panel up and off of the dryer.

  • While you have the dryer cabinet open, vacuum the dust and lint from the dryer cabinet.
  • Remove the screws from the back of the dryer top panel.
  • Release the tabs behind the front console.
  • Pull the top panel up and off the dryer.
 Remove the electronic control board

Take a digital picture of the wiring connections so you can connect the new control board correctly. Using a slot screwdriver, release the locking tabs from the wire connectors. Pull the wire harness plug from the connection receptacle on the electronic control board. Remove the single hex head screw with a 1/4″ nut driver. Slide the electronic control board to release it from the support bracket slots. Set the electronic control board aside for disposal.

Tip: With some units, the wire harness has enough slack to let you detach connections one at a time and immediately attach them to the new control board a sure way to get the connections right.
  • Release the locking tabs on the control board wire harness connectors.
  • Remove the control board mounting screw.
  • Remove the control board from the support bracket.
  • Attach the new electronic control board

    Before removing the new control board from the package, touch the dryer’s metal cabinet to dissipate static electricity. Position the new control board on the support bracket and push it into the mounting slots. Lock it into place so it lines up the mounting screw hole. Replace the mounting screw. Avoid overtightening by turning the screw with the nut driver until it stops and then give the screw one firm twist to snug it in place.

    TipIf you have a grounding strap, put it on and clip the lead to the cabinet before touching the new control board.
  • Connect the wires

    Using your digital photo as a guide, connect the wires to the new electronic control board. Push the wire harness plug until its locking tab snaps into place. The plugs fit together only one way; if they aren’t fitting together easily, reorient them. Never force the plugs into place.

    Warning: Connecting the wires incorrectly can damage dryer components. If you’re unsure about the connections, have a service technician complete the repair.
  • Reinstall the top panel

    Place the panel on the top of the dryer and position it slightly away from the tabs behind the control panel. Push the panel forward to engage the tabs. Work the panel into place and replace the mounting screws at the back of the dryer.

  • . Restore the power

    Turn on the gas supply to the dryer. Plug the dryer into the wall outlet.

Leave a Reply

Your email address will not be published. Required fields are marked *