AEG Induction Cooker Error Codes We have collected all the error codes of AEG induction cookers with a detailed description of the causes of malfunctions, diagnostics and repair. For convenience, arranged in a convenient and understandable table below.
AEG Induction Cooker Error Code Solutions
The models with the display show the alphanumeric combination on your display, find it in the table and find out the reason for the error. Models without a display do not execute the specified program and according to the lit or flashing lights placed on the control panel, you can find out the problem.
| Error code | Description | Causes and solution |
|---|---|---|
| L | On the hob, child protection is activated. | Turn on the hob and hold the lock button for 4 seconds. Further, a characteristic signal will be dulled, and the display will show the removal of protection. |
| F | Use of unsuitable cookware. | Use cookware with a flat bottom, the same diameter as the burner. Perhaps you are using cookware without a ferromagnetic alloy – this cannot be done. |
| E1 | The electronics module has failed due to overheating. | Allow the hob to cool. There might have been a short circuit in the network, in which case, contact a service center to diagnose the module. |
| E2 | The burner control module does not work. | Contact the service to diagnose the modules; you need to replace them. Perhaps the contacts have disappeared or oxidized – the master will establish the exact cause of the malfunction. Contact the service to diagnose the modules; you need to replace them. |
| E3 | Lost connection with inverter. | Due to a short circuit, the transistors in the module burned out. Perhaps the circuit is simply open and the contacts need to be soldered. Contact service to replace them. |
| E4 | Burner temperature exceeded. | Reduce power; let the burner cool. You can turn off the stove until completely cooled. Check ventilation clearances. If you cannot hear the fan noise, it has burned out and needs to be replaced. |
| E5 | The control module did not work, the backlight does not light. | Reload your hob. Most likely the contacts have blown or diodes need replacing. Contact the service center, the master will be able to fix everything. |
| E6 | No connection to power inverter. | A power inverter could burn out due to a power surge or factory fault. Turn off the stove and immediately contact the service center to check out the wizard for diagnosis. |
| E7 | Cooling fan does not work. | Most likely the fan is burned out or dirty. Clean it from dust; if it does not work, call a specialist. The wizard will be able to fix it and at the same time check the ventilation on the panel. |
| E8 | Communication failure between indication and power unit. | Open circuit and burnout lead to such undesirable consequences. Be careful not repair anything yourself. Call the service center wizard to repair the units and replace them. |
| E9 | The problem with the configuration. | Remove the glass and the display connector, put the hob glass in place, if the problem is not resolved, contact the service center to replace the display board. |
| E22 | Clamping multiple buttons. | Perhaps spilled water on the buttons; wipe the hob. Reboot, if the problem is not resolved, contact the service. |