Dacor Oven Error Codes Range/Stove/Oven Fault Codes If you’re looking for help fixing your Dacor Range, look no further! Our comprehensive Dacor Range error code guide will explain common issues, provide tips, and show you how to read your model’s error codes.
DACOR Oven Error Code Solutions
| Failure Code | Condition | Check/Repair |
| F0 | Clock pushbutton is jammed in a down position | Inspect clock buttons |
| F1 | Failure of element relay circuit | Recommended to replace control board |
| F2 | Oven temperature exceeded the clean runaway temperature in self clean more, or the cooking runaway temperature in the cooking mode | Call for service |
| F3 | Oven temperature sensor is short circuit | Verify oven temperature sensor for stability, if no resistance, recommended to replace oven temperature sensor |
| F4 | Oven temperature sensor is short circuit | Verify oven temperature sensor for stability, if no resistance, recommended to replace oven temperature sensor |
| F6 | FEEPROM check comparison failure, time of day and timer will operate | Call for service, Recommended to replace electronic clock control |
| F7 | Self- clean automatic door latch system failure | Inspect door latch and switch(es) |
| F8 | Door latch motor failure. Occurs when motor runs for 2 minutes without the door locking in self-clean mode | Inspect door latch and lock motor |
Note: Depending upon the brand of appliance, there can be many different names for the ‘clock’ component. Electronic Range Control, ERC, Electronic Oven Control, EOC, control board, and clock all refer to the same part.
F0 –Function Key Stuck – Replace either touch pad, or touch pad and control board (clock) if all one assembly.
F1 – System Watchdog Circuit – Select ‘cancel’ and wait 30 seconds. If beeping continues, replace control board (clock).
F2 – Heating Mode High Temperature – This error will occur when the control board (clock) senses a runaway heat condition or when the temperature exceeds runaway limits. This error, along with a beeping, will continue until ‘cancel’ is selected. If the error repeats, check the oven sensor and wiring, as well as for a stuck relay. If error stops, make sure the oven will complete a clean cycle with no further errors.
F3 – Shorted Oven Temperature Sensor (RTD) – Check the connection between the oven control and oven sensor, as well as the sensor harness. If wiring is ok, replace oven temperature sensor (RTD).
F4 – Open Oven Temperature Sensor (RTD) – Check the connection between the oven control and oven sensor, as well as the sensor harness. If wiring is ok, replace oven temperature sensor (RTD).
F6 – EEPROM Checksum Error – Replace control board (clock).
F7 – Door Lock Enabled Above Temperature – Check door lock switches and wiring.
F8 – Door Locking Switch – Check door lock switches and wiring.