Jenn-Air Oven Error Codes Ovens confidently occupied a place of honor in our kitchens. They save time for food warming, time for washing of dishes, because one can warm food on a plate. Repairs and maintenance service of a oven are an integral part of life of any technical and electric appliance. The troubleshooting table with error codes for Jenn-Air ovens below contributes to the revelation of the most often found malfunctions and defects.
Jenn-Air Oven Error Code Solutions
Jenn Air Range / Stove / Oven Fault Codes | ||
Failure Code | Fault Code Description | Solution |
F0 | Function key stuck | Replace touch pad or if touch pad is part of the clock, replace the clock (ERC). |
F1 | Defective touch pad or clock (ERC) | Replace touch pad or clock (ERC). Touch pad is a more common problem. Refer to F1 test at the top of this page for more information. |
F2 | Oven temperature too hot | Replace relay board, if present, or oven temperature sensor (RTD). Check sensor harness. |
F3 or F4 | Shorted or open oven temperature sensor (RTD) | Check sensor harness and harness connection between oven sensor and oven control. Replace oven temperature sensor (RTD) if wiring is ok. |
F5 | Watchdog and hardware conflict | Replace clock (ERC). |
F7 | Function key shorted or stuck | Replace touch pad or if touch pad is part of the clock, replace the clock (ERC). |
F8 | Analog / Digital problem | Replace clock (ERC). |
F9 | Door latch | Check door latch components. |
JENN AIR
Range/Stove/Oven Fault Codes
Failure Code | Condition | Check/Repair |
F1 | Power to element relay energized during time of day display | Wiring harness shorted or change power relay board (PRB) Note: for double ovens, change second oven board |
F2 | Oven temp sensed; over 600F sensed by control in time of day mode, bake mode, or over 900F sensed in clean mode. | Ohm test the oven temperature sensor, if OK, change power relay board. |
F3 | Cooling fan on with no oven function selected | Check oven temperature sensor or wire harness to oven temperature sensor |
F4 | Shorted oven temperature sensor | Check oven temperature sensor or wire harness to oven temperature sensor |
F5 | Power to element relays disabled in cook mode | 1. Intermittent oven temperature sensor or wire harness or, 2. Intermittent contact on power relay board |
F7 | Shorted key sensed for 32 seconds | 1. Membrane shorted, or, 2. Display board defective |
F8 | Shorted meat probe alarm | 1. Probe jack or harness to probe jack, or, 2. Probe sensing temp above 250F |
F9 | Door lock safety circuit on power relay board sensed | Replace power relay board |
FF | Invalid temp reading on power relay board (PRB) | Check oven temperature sensor and wire harness, or replace power relay board |
F | Communication error between boards | Wiring harness, check harness wires for continuity, or replace power relay board |
FC | Communication error between boards | Wiring harness or power relay board (PRB) |
FR | Second oven error sensed | 1. Check oven temperature sensor and harness, or, 2. Replace second board |