Daewoo Washing Machine Error Codes

by

Daewoo Washing Machine Error Codes The vast majority of failures and faults that occur in daily use of the machine can be eliminated personally. In many cases time and costs could be saved without necessarily having to contact The manufacturer srl authorized technical service centre. The following table will aid to identify and possibly eliminate the causes of failure/malfunction.

Daewoo Washing Machine Error Code Solutions

Daewoo Washing Machine Control Panel

Troubleshooting

All repairing operations required for your machine should be carried out by our authorised service provider.If your machine requires a repair or if you cannot remove the fault by the help of the information provided as follows:

  • Unplug your machine.
  • Turn the water faucet off.
ProblemPossible Solution
The door does not open
  • Make sure the red pilot lamp turns off
  • Make the special function SOAK or RINSE HOLD is not activated
  • Push the door from the door locking side or give a slight tap and at the same time pull it to open
The is water on the floor
  • Make sure the red pilot lamp turns off
  • Make the special function SOAK or RINSE HOLD is not activated
  • Push the door from the door locking side or give a slight tap and at the same time pull it to open
The washing machine pelting in water even when it is off
  • Make sure the red pilot lamp turns off
  • Make the special function SOAK or RINSE HOLD is not activated
  • Push the door from the door locking side or give a slight tap and at the same time pull it to open
The machine vibrates noticeably
  • Ensure that the transportation screws have been removed during installation
  • Ensure using the correct detergent for washing machine
  • Make sure that the laundry is not amassed or knotted and that the spin speed is adequate for the laundry load. It so recommended that for excessive laundry load and less than half the nominal load capacity set the spin speed to low
  • Make sure the drain pump filter is not clean. Ensure that the drain pump is squashed and that the machine dranins effectively
  • Ensure that the machine is properly levelled on floor. It is recommeded that for any eventual feet imbalance compensation the feet must regulated and lock them in place with the locking knob ( see figure on page 10)
The machine does not turn on or start
  • Make sure that the power plug is inserted.
  • Make sure there is power in the socket.
  • Make sure that the selector switch, programme selector knob 1, is not in the OFF position.

Most problems are easily solved if you understand the cause. Check the following list for problem before calling for service. If the error mode such as IE, OE, UE were displayed on the control part, in order to solve these problem, first turn off the power of the washing machine and then turn on the power pressing Power button. If PFE error mode was displayed on the control part, in order to solve this problem, first turn off the power of the washing machine, second turn on the power pressing Power button, third press SPIN button and last press Start/Hold button.

Automatic Fault Warnings And What To Be Done

Your machine is equipped with the systems which are capa- ble of both taking necessary precautions and warning you in case of any breakdown by means of continuous self-check- ing during washing operations.

Leave a Comment